fadini Junior 650 Notice D'instructions page 24

JUNIOR 633
JUNIOR 650
ANCHORING THE JUNIOR
1
ELECTRICAL POWER SUPPLY TO THE PROGRAMMER
!
ATTENTION: disconnect
the 230 Vac electrical power supply
from the electrical system
NO
DISTINCTION OF JUNIOR INSTALLED ON THE RIGHT OR LEFT
The first operation to be performed is to identify the Junior installation with respect to the opening of the gate, moving dip-switch n° 11 on
the Elpro 65 programmer (already installed on the Junior 633/Junior 650), depending on the position of Junior as seen inside the gate to be
opened (Pic. 10).
opening direction
Junior installed to the LEFT:
position dip-switch n° 11 to OFF
OFF
electro-mechanical sliding gate operator
2
2 230 V V
!
2 mm
Terminal board for Junior
power supply
Junior installed to the RIGHT:
position dip-switch n° 11 to ON
24
3
opening direction
Pic. 8
Pic. 9
ON
Pic. 10