fadini Junior 650 Notice D'instructions page 23

JUNIOR 633
JUNIOR 650
CASING OPENING
ATTENTION: once the two side screws have
!
been removed, lift the casing and vertically
pull it out, without tearing off the led card
cable connector.
ANCHORING WITH A BASE PLATE
Position and anchor the base plate at a distance of 60 mm from the
gate to be opened, levelling it flat.
60 mm
electro-mechanical sliding gate operator
Pic. 4
!
Junction box
Pic. 6
ANCHOR PLATE
ATTENTION: the nut under the plate must be
47 mm from the end of the bolt.
- n° 1 base plate
- n° 4 anchor bolts
- n° 8x M10 hexagonal nuts+washers
ANCHORING WITH PLUGS (not supplied)
It is important that the threading should project 40 mm from the
ground.
60 mm
Junction box
23
47 mm
Pic. 5
!
Pic. 7