Publicité
Les langues disponibles
Les langues disponibles
Fitting the loop handle
•
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
•
Fit the bolt, securing plate and wing nut as shown in
the diagram.
•
Tighten the wing nut.
Assembling the angle gear
•
Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.
•
Position the angle gear so that its slot is aligned with
the line on the supporting tube.
•
Firmly tighten the screw.
36 – English
ASSEMBLY
Assembling the cutting
equipment
!
!
Assembling the blade
Fit the blade as follows:
1
Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
2
Block the blade rotation by inserting the locking pin in
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3
Fit the blade (B) on the drive disc.
4
Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Under no circumstances may
the edge cutter blade be used without the
blade guard fitted.
1153255-32 Rev.1 2010-02-02
Publicité
