Publicité
Les langues disponibles
Les langues disponibles
CHARGING THE BATTERY
The Dogtra YS300 uses a lithium polymer battery.
Recharge the unit if the indicator light is red or does not
come on.
NOTE 1: Only use Dogtra-approved batteries, chargers,
and accessories for your Dogtra system. This will prevent
any damage that can be incurred from attempting to use a
different charger.
NOTE 2: The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the system, be sure to give
it a full 2-hour initial charge before the first use away from
any flammable substances.
NOTE 3: When a charger is not in use, disconnect it from
the power source. Fully charge the batteries if the unit is to
be stored without use for a period of 3 months or more.
12
1. Open the rubber plug on the battery charging
receptacle and plug in the charging cable.
2. Plug the charger into a 120 volt wall outlet or, if using
the auto charger, plug into a cigarette lighter for lithium
polymer batteries. All indicator lights should glow red
when properly plugged in and the unit will automatically
shut off during the charging process.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process and turn green once the unit is fully charged.
4. After charging the unit, cover the battery charging
receptacle with the rubber plug on the receiver.
13
Publicité
