Publicité
Les langues disponibles
Les langues disponibles
LED INDICATOR
The LED indicator light will flash for 1 second when the
YS300 has been turned on and then flash every 2 seconds.
If the dog does not bark for over 10 seconds, it will turn to
sleep mode to conserve battery life and the LED will turn
off.
Before going into sleep mode, the LED light flashes
green when the battery is fully charged and turns to
amber when the battery life is getting low. When the LED
indicator emits a blinking red light, the battery needs to be
recharged.
Battery life
Full charge
LED window
In Use
Green
Charging
Green
10
Medium charge
Needs charge
Amber
Red
Red
Red
TESTING THE YS300
1. Turn the dial on the YS300 to "T" to set the system to
test mode.
2. Test the unit by scratching the TEST area on the receiver
(as shown in the diagram) with a coin or pen. The
receiver will emit a vibration three times. Repeat the
same process to test again.
3. The YS300 has a preset delay of 15 seconds in between
corrections. Once the unit activates, it will not activate
again until 15 seconds has gone by. The reason for the
delay is so that your dog figures out the implications
of the corrections from barking before being corrected
again.
* When on the test mode, the YS300 emits a vibration
without emitting stimulation at the same time.
* When on the test mode, the sensor is more sensitive and
can be easily activated by a small sound or tap.
11
Publicité
