Publicité
Les langues disponibles
Les langues disponibles
Unpack Grill
WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack grill. Remove all packaging materials and remove grill
from carton.
Move grill close to desired outdoor location.
Open the hood.
Remove Packaging Material Inside the Grill
1. Cut the tiedowns holding the grates together.
2. Remove rotisserie skewer (on some models), warming shelf
and grill grates from inside the grill and remove packaging
material.
3. Remove foam block and wrap from inside the grill.
A
A. Foam block
B. Foam wrap
4. Replace the grill grates.
5. Place warming shelf on brackets as shown.
A
A. Warming shelf brackets
B. Warming shelf
INSTALLATION INSTRUCTIONS
B
A
6. On some models, install rotisserie mounting bracket using
2 screws.
7. Dispose of/recycle all packaging material.
NOTE: If grill has been converted to LP gas, follow instructions in
"Conversion to LP Gas" at the end of this section.
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.
B
Natural Gas Use
The installation of this grill must conform with local codes or, in
the absence of local codes, with either the National Fuel Gas
Code, ANSI Z223.1/NPFA 54, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and Handling
Code, B149.2.
1. Place grill into outdoor enclosure, but leave enough room in
back to connect to gas supply and electrical plug-in.
Use a new CSA International approved "outdoor"
gas supply line.
Securely tighten all gas connections.
Failure to do so can result in death, explosion, or fire.
2. Make gas connections.
A combination of pipe fittings must be used to connect the
grill to the existing gas line.
A
B
A. 2 screws
B. Rotisserie bracket
Make Gas Connection
WARNING
Fire Hazard
WARNING
Explosion Hazard
11
Publicité
