Kettler Opal 200 Instructions De Montage page 5

Assembly Instructions
– The equipment is dependent of revolutions per minute.
– A slight production of noise at the bearing of the centrifugal mass
is due to the construction and has no negative effect upon ope-
ration. Possibly occurring noise during reverse pedalling result
from engineering and are absolutely safe.
– The crosstrainer has a magnetic brake system.
– To operate correctly, the pulse function requires a minimum
voltage of 2,7 volts (only for computers working with batteries).
Instructions for Assembly
– Ensure that you have received all the parts required (see check
list) and that they are undamaged. Should you have any cause
for complaint, please contact your KETTLER dealer.
– Before assembling the equipment, study the drawings carefully
and carry out the operations in the order shown by the diagrams.
The correct sequence is given in capital letters.
– Please note that there is always a danger of injury when working
with tools or doing manual work. Therefore please be careful
when assembling this machine.
– Ensure that your working area is free of possible sources of
danger, for example don't leave any tools lying around. Always
dispose packaging material in such a way that it may not cause
any danger. There is always a risk of suffocation if children play
with plastic bags!
– The equipment must be assembled with due care by an adult
person. If in doubt call upon the help of a second person, if pos-
sible technically talented.
List of spare parts page 28-29
– When ordering spare parts, always state the full article number,
spare-partnumber, the quantity required and the S/N of the
product (see handling).
– Example order: Art. no. 07625-990 / spare-part no. 68003705
/ 1 pieces / S/N ....................
– Please keep original packaging of this article, so that it may be
used for transport at a later date, if necessary.
– Goods may only be returned after prior arrangement and in
(internal) packaging, which is safe for transportation, in the ori-
ginal box if possible.
– It is important to provide a detailed defect description / damage
report!
– Important: spare part prices do not include fastening material;
if fastening material (bolts, nuts, washers etc.) is required, this
should be clearly stated on the order by adding the words „with
fastening material".
Waste Disposal
KETTLER products are recyclable. At the end of its
useful life please dispose of this article correctly and
safely (local refuse sites).
All manuals and user guides at all-guides.com
– Before beginning your first training session, familiarize yourself
thoroughly with all the functions and settings of the unit.
– The surface on which the unit is placed must be firm and even.
Place rubber or straw mats under it to deaden any noise or
impacts. Only for appliances with weights. Avoid powerful
oscillations of the dumbbells!
– The fastening material required for each assembly step is shown
in the diagram inset. Use the fastening material exactly as
instructed. The required tools are supplied with the equipment.
– Bolt all the parts together loosely at first, and check that they
have been assembled correctly. Tighten the locknuts by hand
until resistance is felt, then use spanner to finally tighten nuts com-
pletely against resistance (locking device). Then check that all
screw connections have been tightened firmly. Attention: once
locknuts have been unscrewed they no longer function cor-
rectly (the locking device is destroyed), and must be replaced.
– For technical reasons, we reserve the right to carry out preliminary
assembly work (e.g. addition of tubing plugs).
GB KETTLER GB Ltd. · KETTLER House, Merse Road · North
Moons Moat · Redditch, Worcestershire B98 9HL
http://www.kettler.co.uk
USA KETTLER International Inc. · 1355 London Bridge Road ·
Virginia Beach, VA 23453
http://www.kettlerusa.com
http://www.kettler.ch
GB
5