Télécharger Imprimer la page

BorMann Pro BCP3800 Manuel D'utilisation page 4

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
EN
SAFETY INSTRUCTIONS FOR THE BATTERY CHARGER
WARNING: To reduce the risk of electric shock or damage to the charger and battery, charge only those lithium-ion rechargeable batteries as specifically
designated on your charger's label. Other types of batteries may burst, causing personal injury or damage.
1. Before using battery charger, read all instructions and cautionary markings in this manual and on the battery charger, the battery and the product using the
battery to prevent misuse of the products and possible injury or damage.
2. Do not use the charger outdoors or expose it to wet or damp conditions. Water entering the charger will increase the risk of electric shock.
3. Use of an attachment not recommended or sold by the battery-charger manufacturer may result in a risk of fire, electric shock or injury to persons.
4. Do not abuse the cord or charger. Never use the cord to carry the charger. Do not pull the charger cord to disconnect the plug from receptacle. Damage to
the cord or charger could occur and create an electric shock hazard. Replace damaged cords immediately.
5. Make sure that the cord is located so that it will not be stepped on, tripped over, come in contact with sharp edges or moving parts, or otherwise subjected
to damage or stress. This will reduce the risk of accidental falls, which could cause injury and damage to the cord, which could then result in electric shock.
6. Keep cord and charger from heat to prevent damage to housing or internal parts.
7. Do not allow gasoline, oils, petroleum-based products, etc. to come in contact with plastic parts. These materials contain chemicals that can damage,
weaken, or destroy plastic.
8. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a risk of fire and electric shock. If an
extension cord must be used, make sure that: The pins on plug of extension cord are the same number, size and shape as those of the plug on charger. The
cord is properly wired and in good electrical condition
9. Do not operate the charger with a damaged cord or plug, which could cause shorting and electric shock. If damaged, have the charger repaired or replaced
by an authorized service technician at a Service Center.
10. Do not operate the charger if it has been damaged in any way. Take it to an authorized service technician at a Service Center for an electrical check to
determine if the charger is in good working order.
11. Do not disassemble the charger. Take it to an authorized service technician at a Service Center when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12. Unplug the charger from the electrical outlet before attempting any maintenance or cleaning to reduce the risk of electric shock.
13. Disconnect charger from the power supply when not in use. This will reduce the risk of electric shock or damage to the charger if metal items should fall
into the opening. It will also help prevent damage to the charger during a power surge.
14. Risk of electric shock. Do not touch the uninsulated portion of output connector or uninsulated battery terminal.
OPERATION
TO ATTACH BATTERY PACK
Align the raised rib on the battery pack with the grooves on the bottom of the tool and then attach the battery pack to the tool.
NOTE: Make sure that the latch on the battery pack snaps into place and the battery pack is secured to the tool before beginning operation. To remove the
battery pack from the tool, depress the battery release button located on either side of the battery pack, and pull the battery pack out and remove it from the
tool.
WARNING: To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your tool, battery pack or charger in fluid or
allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain industrial chemicals and bleach or bleach-containing products, etc
can cause a short circuit.
WARNING: If any parts are damaged or missing, do not operate this product until the parts are replaced. Use of this product with damaged or missing parts
could result in serious personal injury.
4
Battery-release button
WWW.NIKOLAOUTOOLS.COM

Publicité

loading

Ce manuel est également adapté pour:

070528