Makita GA048G Manuel D'instructions page 14

Place the tool upside down to allow easy access to the
spindle.
Remove any accessories on spindle. Thread wire wheel
brush onto spindle and tighten with the wrenches.
Fig.21
► 1. Wire wheel brush
Installing hole cutter
Optional accessory
Place the tool upside down to allow easy access to the
spindle.
Remove any accessories on the spindle. Thread the
hole cutter onto the spindle, and tighten it with the sup-
plied wrench.
Fig.22
► 1. Hole cutter
Installing dust collecting wheel
guard for grinding
Only for model GA049G / GA050G
Optional accessory
With optional accessories, you can use this tool for
planing concrete surface.
CAUTION:
Dust collecting wheel guard for
grinding is only for use in planing concrete sur-
face with a cup-type diamond wheel. Do not use
this guard with any other cutting accessory or for
any other purpose.
CAUTION:
Before operation, make sure that
a vacuum cleaner is connected to the tool and
turned on.
Place the tool upside down and install the dust collect-
ing wheel guard.
Mount the inner flange onto the spindle.
Fit the cup-type diamond wheel on the inner flange and
tighten the lock nut onto the spindle.
1
2
1
4
Fig.23
► 1. Lock nut 2. Cup-type diamond wheel 3. Hubbed
NOTE: For information how to install the dust col-
lecting wheel guard, refer to the manual of the dust
collecting wheel guard.
Installing dust collecting wheel
guard for cutting-off
1
Only for model GA048G / GA049G / GA050G
Optional accessory
With optional accessories, you can use this tool for
cutting stone materials.
Fig.24
NOTE: For information how to install the dust col-
lecting wheel guard, refer to the manual of the dust
collecting wheel guard.
14 ENGLISH
5
6
cup-type diamond wheel 4. Inner flange 5. Dust
collecting wheel guard 6. Bearing box
3