Publicité
Les langues disponibles
Les langues disponibles
Refer to the following figures.
For 100 mm (4") model
When installing the abrasive cut-off wheel:
16 mm (5/8")
Fig.16
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4 mm
(5/32")) 3. Abrasive cut-off wheel (4 mm (5/32") or thicker)
4. Inner flange
When installing the diamond wheel:
Fig.17
► 1. Lock nut 2. Diamond wheel (Thinner than 4 mm
(5/32")) 3. Diamond wheel (4 mm (5/32") or thicker)
4. Inner flange
For model other than 100 mm (4")
When installing the abrasive cut-off wheel:
Fig.18
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4 mm
(5/32")) 3. Abrasive cut-off wheel (4 mm (5/32") or thicker)
4. Inner flange
1
1
2
3
16 mm (5/8")
4
4
1
1
2
3
4
4
1
1
2
3
4
4
When installing the diamond wheel:
Fig.19
► 1. Lock nut 2. Diamond wheel (Thinner than 4 mm
(5/32")) 3. Diamond wheel (4 mm (5/32") or thicker)
4. Inner flange
Installing wire cup brush
Optional accessory
CAUTION:
Do not use wire cup brush that
is damaged, or which is out of balance. Use of
damaged wire cup brush could increase potential for
injury from contact with broken brush wires.
Place the tool upside down to allow easy access to the
spindle.
Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with supplied wrench.
Fig.20
► 1. Wire cup brush
Installing wire wheel brush
Optional accessory
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
ALWAYS use guard with wire
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
13 ENGLISH
1
1
2
3
4
4
1
Publicité
