Complete The Installation; Range Hood Use; Range Hood Care; Cleaning - Whirlpool WVU17UC0JS Instructions D'installation Et Guide D'utilisation Et D'entretien

Option 2 - Power Cord Kit Installations
For optional power cord kit installations, follow the instructions
supplied with the power cord kit. See the "Assistance or
Service" section for information on ordering.
NOTE: Use only with range hood cord connection kits that have
been investigated and found acceptable for use with this model
range hood.

14. Complete the Installation

Install a 120 V, 75 W maximum, incandescent light bulb with
■
E26 base. See "Replacing the Incandescent Light Bulb" in
the "Range Hood Care" section.
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after
the cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the front panel of the range
hood.
C
A. LED light housing and cover
B. Grease filter retainer
C. Grease filter
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace the grease filter
before operating hood.
Exterior Surfaces:
IMPORTANT: Do not use soap-filled scouring pads, abrasive
cleaners, cooktop polishing creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use cleaners that
contain chlorine.
Cleaning Method:
Liquid detergent or all-purpose cleaner:
■
Rinse with clean water and dry with a soft, lint-free cloth.
Glass cleaner to remove fingerprints.
■
For stainless steel models, use Stainless Steel Cleaner and
■
Polish: See the "Assistance or Service" section to order.
For stainless steel models, rub in the direction of the grain to
■
avoid scratching or damaging the surface.
10

RANGE HOOD USE

B
A

RANGE HOOD CARE

Cleaning

If removed previously, replace the filter. See "Grease or
■
Charcoal Filter" in the "Range Hood Care" section.
For vented installations: Install a metal filter.
For non-vented (recirculating) installations: Install a
charcoal filter.
Check the operation of the range hood fan and light. See the
■
"Range Hood Use" section.
If the range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
Disconnect the power and check the wiring connections.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.

Range Hood Controls

On
A
A. On/Off light switch
B. Fan speed switch
Operating the light
Press the light switch to the left to turn the light On. Press the
light switch to the right to turn the light Off.
IMPORTANT: Flicker and visual fluctuation can be present every
time the lamp switch is activated. The duration of the flicker will
depend on the manner and velocity that the light switch changes
position.
Operating the fan
The fan has 2 speeds.
Press the fan switch to the left for Low speed. Press the fan
switch to the right for High speed. Return the fan switch to the
center to turn the fan Off.
Grease or Charcoal Filter
To Clean the Filter:
1. Remove the screw from the grease filter retainer.
2. Push the grease filter retainer to release the filter.
B
A. Filter retainer screws
B. Grease filters
C. Filter retainer
Off
High
Off Low
B
C
A
A