Dell Precision 3660 Manuel De Maintenance page 43

About this task
The following images indicate the location of the processor fan and 125W air-cooler heat-sink assembly and provide a visual representation
of the removal procedure.
Steps
1. Disconnect the processor-fan cable from the connector on the system board.
2. In the reverse sequential order (4->3->2->1), loosen the four captive screws that secure the processor fan and heat-sink assembly to
the system board.
3. Lift the processor fan and heat-sink assembly from the system board.
Installing the processor fan and 125W Air-cooler heat-sink assembly
Prerequisites
Si vous remplacez un composant, retirez le composant existant avant d'exécuter la procédure d'installation.
NOTE: If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure that thermal
conductivity is achieved.
About this task
The following images indicate the location of the processor fan and 125W air-cooler heat sink and provide a visual representation of the
installation procedure.
Retrait et installation de composants 43