Panasonic CF-VDL02BM Instructions D'utilisation page 16

Adjusting the LCD Monitor
(Auto Configuration)
Auto Config
Yes
Miscellaneous
E
Init NVRam
OSD Timeout
OSD Position
(Information)
Information
Version:
V-Freq-:
H-Freq-:
PixelCLk:
Width:
Height:
3
Press
The OSD main menu disappears.
16
Auto Phase
A confirmation box is displayed. The default selection
is [Yes]. Press
you want to cancel, select [No] and press
To save the adjusted value, select [Phase] or [Clock],
then press
No
(Miscellaneous)
to adjust the phase automatically. If
.
Auto Configuration automatically adjusts image posi-
tion, clock, and phase.
A confirmation box is displayed. The default selection
is [Yes]. Press to execute the menu. If you want to
cancel, select [No] and press
To save the adjusted value, select [Brightness], then press
Select the item by pressing
Init NVRam
All values of the OSD menu are set to default.
A confirmation box is displayed. The default selection
is [Yes]. Press to execute the menu. (If you want to
cancel, select [No] and press
vated by turning off the power to the LCD Monitor and
then turning the power back on again.
OSD Timeout
OSD Timeout is used to set the OSD idle time-out. If
no active action, key press or automatic configuration
occurs for the defined period, the OSD menu is closed.
There are four OSD time-out values available.
Select the item by pressing
OSD Position
The sub-menu is displayed.
Select the item by pressing
The sub-menu is displayed.
Adjust the OSD Position by pressing
. (To cancel, press
the LCD Monitor. When the power is turned on again,
the operation will be canceled.)
This menu is used to display information about the sys-
tem. The OSD window is displayed. If
the information window is closed and the main menu is
displayed.
.
.
or , then press
.) This setting is acti-
or , then press
or , then press
or , then press
and then turn off the power to
is pressed,
.
.
.
.