Publicité
Les langues disponibles
Les langues disponibles
7.
Select WASH TEMP
Once you select a cycle, select the desired wash temperature
by turning the Wash Temperature knob to the appropriate
setting based on your load. All rinses are cold.
NOTE: Always read and follow fabric-care label instructions to
avoid damage to your garments.
Wash Temp
Hot
Some cold water is added to save
energy. This will be cooler than
your hot-water-heater setting.
Warm
Some cold water will be added,
This will be cooler than what your
previous washer provided.
Cool
Warm water is added to assist in
soil removal and to help dissolve
detergents.
Cold
This is the temperature from your
faucet. If your tap water is very
cold, warm water may be added
to assist in soil removal and help
dissolve detergent.
Tap Cold
This is the temperature from your
faucet.
8.
Select cycle options, if desired
Select the number of rinse cycles you would like the washer
to run by turning the Rinse knob to the appropriate setting.
To presoak garments, turn the Presoak knob to "On."
8
All manuals and user guides at all-guidesbox.com
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
Dark colors that
bleed or fade
Light soils
9.
Press START/Pause
to begin wash cycle
Press the START/Pause button to start the wash cycle. When
the cycle has finished, the Done indicator will light. Promptly
remove garments after cycle has completed to avoid odor,
reduce wrinkling, and prevent rusting of metal hooks, zippers,
and snaps.
Unlocking the Lid to Add Garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause. The lid will unlock once washer
movement has stopped. This may take several minutes if the
load was spinning at high speed. Add garments, close lid, and
press START/Pause again to restart the cycle.
If lid is left open for more than 10 minutes, the water will
pump out automatically.
10.
Add fabric softener, if desired
During the final rinse, wait until the washer has completed
filling and press the START/Pause button to pause the washer.
Lift the lid and add the measured, recommended amount of
liquid fabric softener. Do not use more than the recommended
amount. Close the lid and press the START/Pause button again
to start the washer. Always follow manufacturer's directions for
correct amount of fabric softener based on your load size.
Publicité
