Ryobi RY18LMX37A Traduction Des Instructions Originales page 7

MAINTENANCE
WARNING
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
WARNING
Servicing requires
knowledge and should be performed only
by a qualifi ed service technician. Have the
product serviced by an authorised service
centre only. When servicing, use only
original replacement parts.
■ Turn off the product, and remove the
isolator key and the battery pack. Make
sure that all moving parts have come to
a complete stop before any cleaning or
maintenance task.
■ You may make adjustments and repairs
described in this manual. For other repairs,
contact an authorised service centre.
■ Replace worn or damaged part for safety.
■ Check the grass catcher frequently for
wear or deterioration.
■ After each use, clean the product with a
soft, dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
■ Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition.
■ Be careful during adjustment of the product
to prevent entrapment of the fingers
between moving blades and fixed parts of
the product.
■ When servicing the blades, be aware that
even though the power source is turned off,
the blades can still be moved.
■ The blade on the product is sharp. Use
extreme caution, and wear heavy-duty
gloves when fitting, replacing, cleaning, or
checking bolt security.
■ Replace damaged blades and bolts in sets
to preserve balance.
■ The blade bolts must be adequately
tightened. See
manufacturer's
accessories and
extreme care and
the manufacturer's
recommendations for blade bolt torque,
which can be found in the product
specification table in this manual.
CLEARING BLOCKAGES
■ Turn off the product, and remove the
isolator key and the battery pack. Make
sure that all moving parts have come to a
complete stop.
■ Always wear heavy-duty gloves when
checking or clearing a blockage. The
blades are sharp and the blockage itself
could be a sharp object.
■ Remove the grass catcher, check for and
carefully clear obstructions.
■ Check the grass discharge chute, and
carefully clear blockages.
■ Turn the product on its side. Check its
underside and the area around the blade. If
any blockages are found, remove carefully.
Remember, the blade may move during
cleaning.
RESIDUAL RISKS
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise during use, and the
operator should pay special attention to avoid
the following:
■ injury caused by vibration
– Always use the right tool for the job. Use
designated handles and restrict working
time and exposure.
■ injury caused by noise
– Exposure to noise can cause hearing
injury. Wear ear protection and limit
exposure.
■ injury from contact with the blades
■ injury caused by thrown objects
RISK REDUCTION
It has been reported that vibrations from
handheld tools may contribute to a condition
called Raynaud's Syndrome. Symptoms may
include tingling, numbness and blanching of
the fi ngers, usually apparent upon exposure
to cold. Hereditary factors, exposure to cold
and dampness, diet, smoking and work
practices are all thought to contribute to the
development of these symptoms. There are
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
English | 5