LAVAZZA Jolie&Milk Mode D'emploi page 54

EN IT
Problem encountered
Water leaks at the rear side of
the coffee machine.
Water leaks at the front side
of the coffee machine.
The loading lever does not
reach the supply position or
requires an excessive closing
effort.
Red flashing lights .
Pilot lights ON with white
light and blinking fast.
The coffee flows out too fast
and no creamy froth forms on
the surface.
TROUBLESHOOTING
Possible causes
» Tank not inserted correctly.
» Tank damaged.
» Spent capsule drawer not
inserted correctly.
» Spent capsule drawer filled.
» Capsule stuck.
» Capsule not compatible.
» Spent capsule drawer filled.
» Capsule fitted incorrectly.
» Machine broken.
» Spent capsule drawer filled.
» Capsule not compatible.
» Capsule already used.
Solution
» Insert the tank correctly.
» Check for leaks in the tank keeping it separate from
the machine.
» If the problem remain please contact Lavazza
Customer Service.
» Insert the spent capsule drawer correctly.
» Empty the spent capsule drawer and the drip tray.
» Lift and lower the capsule loading lever. If this is not
enough, disconnect the machine from power mains
and operate manually to remove the capsule from
the duct.
» Use Lavazza capsules or compatibles.
» If the problem remain please contact Lavazza
Customer Service.
» Empty the spent capsule drawer.
» Repeat the sequence, lever in the off position, lever
in the brewing position; if this is not enough, operate
manually to remove the capsule from the duct with the
machine disconnected from power mains.
» Contact Lavazza Customer Service.
» Empty the spent capsule drawer and press one of the
power on/supply buttons to reset the machine.
» Use Lavazza capsules or compatibles.
» Bring the lever back to rest position and load a new
capsule.
» If the problem remain please contact Lavazza
Customer Service.
54