Publicité
Les langues disponibles
Les langues disponibles
the energy consumption
Replacing the lamp
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be changed by the
consumer. The lifespan of these LEDs is normally sufficient and will not likely require a replacement.
However, if the LEDs were defective, despite all the care taken during the manufacture of your appliance,
please contact your after-sales service for any intervention.
7.
TROUBLESHOOTING GUIDE
You can solve many common refrigerator problems easily, saving you the cost of a possible service call. Try
the suggestions below to see if you can solve the problem before calling for service.
Problem
Possible cause
Mains plug is not plugged in or loose
Fuse has blown or is defective
Appliance does
not work
Socket is defective
Appliance freezes
Temperature is set too cold or the
or cools too much
appliance runs at SUPER modes
Temperature is not properly adjusted
Door was open for an extended period
The food is not
A large quantity of warm food was
frozen enough
placed in the appliance within the last 24
hours
The appliance is near a heat source
Heavy build up of
frost on the door
Door seal is not air tight
seal
Appliance is not level
The appliance is touching the wall or
other objects
Unusual noises
A component e.g. a pipe, on the rear of
the appliance is touching another part of
the appliance or the wall
Side panels are
It's normal. Heat exchange is in the side
hot
panels
Solution
Insert mains plug
Check fuse, replace if necessary
Mains malfunctions are to be corrected by an
electrician
Turn the temperature regulator to a warmer
setting temporarily
Please look in the initial temperature setting
section
Open the door only as long as necessary
Turn the temperature regulator to a colder
setting temporarily
Please look in the installation location section
Carefully warm the leaking sections of the door
seal with a hair dryer (on a cool setting). At the
same time shape the warmed door seal by hand
such that it sits correctly
Re-adjust the feet
Move the appliance slightly
If necessary, carefully bend the component out
of the way
Take gloves to touch side panels if needed.
35
Publicité
