Rating Plate; Installation; Technical Data - tormatic T100 DES Notice De Montage Et D'utilisation

Rating plate

The rating plate is located at the side on the control housing. Ob-
serve the power supply specifications.
1
7
Made in Germany
6 5 4
1 Control type
2 Manufacturer and address
3 Supply voltage
4 Amperage

Technical data

Height x width x depth
Cable feed-throughs
Supply voltage
Control voltage
Max. motor power
Safety according to
EN 13849-1:
Protection type
Operating temperature
Manufacturer
20 - EN
2
3
5 Max. motor power
6 Protection type
7 WN number
250 mm x 215 mm x 120 mm
Assembled vertically
6 x M20
2 x M16
2 x M20 V cutout
3N~ 400 V
3~ 230 V
1N~ 230 V
24 V DC
Max. 3.0 kW
Input STOP A: Cat 2 / PL = C
Input STOP B: Cat. 2 / PL = C
Input STOP C: Cat. 2 / PL = C
IP 54, optional IP 65
+50 °C
-20 °C
Novoferm tormatic GmbH
Eisenhüttenweg 6
D-44145 Dortmund
www.tormatic.de
4

Installation

Hazardous voltage
DANGER
The product runs on high voltage Before starting
with the installation,observe the following:
• Have all work on electrical connections car-
ried out by a skilled electrician.
• The power connection must be executed in
compliance with the mains voltage avail-
able.
Follow the instructions as well as the illustrations in the
"Connection diagrams" chapter.
1. Tools required
For the assembly of the control, you require the following tools:
• wooden folding rule or tape measure
• cross-tip screwdriver Phillips; size 2
• drilling machine
• drill 6 mm
• Torx screwdriver, size T20
• slotted screwdriver for electricians
• spirit level
• marking pencil
2. Opening the control cover
Open the housing cover by either loosening the two screws on
the left or right on the cover.
3. Assembly of the control
Assemble the control as specified on the drilling drawing.
Selection of the place of installation
NOTICE
When selecting the place of installation, observe
the preconditions in compliance with the tech-
nical data.
4. Terminal designation
J1 Start / pulse input (OPEN / STOP / CLOSE
J2 Photoelectric safety barrier 2- or 4-wire
J3 Safety edge OSE / 8K2 / DW
J4 Emergency stop, slack rope, locking
J7 Key switch / pull switch
J9 Digital limit switch - motor cable
J10 Connection of extended controls
J11 Connection of radio receiver
J12 Antenna
J13 Membrane keypad
X1 Power connection
X2 Power output L, N (500 W / 230 V)
X3 Protective earth contact
X5 Potential-free relay contact 1, door status relay
X6 Potential-free relay contact 2, door status relay
X7 Door drive
X8 24 V DC, max. 200 mA
T100 DES