ISE SY-2027 Manuel De L'utilisateur page 21

Attention: the upturned piece should be outward. Screw two M8*16mm bolts, two split
washer, and two flat washers under the rail.
And then screw more two M8*16mm bolts, two split washer, and two flat washers into the
open of the rail to fix the connecting sheet.
Disassemble one side of the lock bolt set. Insert to the horizontal hole of the rail and
screw the rubber pad and the lock bolt back. Rotate the rubber pads upright to fix.
Cover the rear rail cover and
STEP 4: ASSEMBLING THE RAIL
Connect the rail and the frame.
Screw the M10*100mm hex bolt (No.26)and
the M10 lock nut (No.27) to the holenear to
the frame by using two open endwrenches
(No.33).
lnsert the detent pin (No.28) to the holenear
to the rail. Finally, screw the knob bolt(No.29)
to fix.
STEP 3: ASSEMBLE THE SEAT AND
REAR OF THE RAIL
For the step, please prepare a lock bolt set(-
No.6), the seat(No.7), rear support(No.8),
connecting sheet(No.9), rear rail cover(No.lO),
four M8*16mm bolts(No.20), four split wash-
ers(No.21), four flat washers(No.22), M5*16
bolt(No.23), and two Allen wrenches(No.32).
Install the seat to the rail. Attach the rear sup-
port under the rail. Inset the connecting sheet
into the open of the rail.
8
EN
EN