Parkside 5 20 01 10003 Instructions D'utilisation Et Consignes De Sécurité page 15

Specific safety

instructions
Changes as a result of technical
Q
progress can be introduced by
the manufacturer without prior
notice and may not be included
in the Operating Instructions.
Check the equipment before
Q
putting it into service to see that
it is complete, functions properly
and is air tight!
Never put a defective or
Q
non-functional piece of equip-
ment into service. Contact the
manufacturer or get the equip-
ment checked by a qualified
technician.
Never stand on the equipment!
Q
Hold the hose when unrolling
Q
and rolling up so that the hose
cannot injure anyone while
swinging about.
Pay attention to the maximum
Q
working pressure of the hose.
Only operate the hose within
the given parameters (see
Technical data).
At very low temperatures the
Q
hose may become inflexible and
stiff. This can lead to problems
when rolling up!
Take care when the hose is mo-
Q
ved it is not damaged by sharp
edges and objects.
16 GB/IE
Never store or put the hose in
Q
a place where there is direct
sunlight.
Never use the hose to carry
Q
dangerous liquids (chemicals,
acids, alkaline solutions, etc).
Turn off the air flow before
Q
rolling up the hose.
Always work cautiously and
Q
with the necessary care.
Never use excessive force.
Q
Operation

Hold the hose when unrolling and rolling up so
that the hose cannot injure anyone while swin-
ging about.
Pay attention to the maximum working pressure of
the hose. Only operate the hose within the given
parameters (see Technical data).
1. Plug the connection hose into the compressor.
2. Slowly unroll the desired length of hose.
3. Connect the compressed air tool by means of the
fast coupling.
Fig. 1 Connect compressed air hose
4. Remove the tool from the hose after the work has
been completed by pulling the coupling back-
wards hard. Roll up the hose again when the job
is done.