Publicité
Les langues disponibles
Les langues disponibles
The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
Do not place the charger and battery pack in an area of
extreme heat or cold. They will work best at normal room
temperature.
NOTE: The charger and battery pack should be placed in
a location where the temperature is more than 10°C but
less than 38°C.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting
to recharge.
MAINTENANCE
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Remove the plug of the product from the power socket
when it is not in use or when cleaning it.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloth or soft brush to remove dirt, dust, etc.
Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
WARNING
Hazardous voltages are present within this product; do
not disassemble.
There are no user service or replacement parts inside
this product. In case of damage or failure please
return to your authorised RYOBI service centre for
professional repair.
STORAGE
Store your charger in a cool dry place between 10 and
25°C.
It is not recommend to leave it in a vehicle during hot or
cold conditions. Ensure no metal filings or swarf can fall
into the vents during storage, as this may cause serious
injury when it is next used.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
2
Original Instructions
European Conformity Mark
British Conformity Mark
EurAsian Conformity Mark
Ukraine Conformity Mark
Class II equipment
Please read the instructions carefully
before starting the machine.
For indoor use only.
Time-lag fuse 2A
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
SYMBOLS IN THIS MANUAL
Connect to the power supply
Disconnect from the power supply
Parts or accessories sold separately
Publicité
