Publicité
Les langues disponibles
Les langues disponibles
USING THE WORK LIGHT
5.3
The work light is controlled by a sliding ON/OFF switch located on the front of the unit.
• Make sure the lamp is turned OFF when the unit is being recharged or stored.
• Position the unit on a flat, stable surface near the intended work area.
• Ensure the battery clamps are securely clipped on the storage holders.
POWERING A 12V DC DEVICE
5.4
The unit is a power source for all 12V DC accessories that are equipped with a 12V accessory plug. Use
it for power outages and on fishing or camping trips.
NOTE: Do not power a 12V device with the unit while charging the internal battery.
1. Make sure the device to be powered is OFF before inserting the 12V DC accessory plug into the 12V
DC accessory outlet.
2. Open the protective cover of the DC power outlet on the unit.
3. Plug the 12V DC device into the DC power outlet and turn on the 12V DC device (if required).
4. When finished, turn off the DC device (if required) and unplug from the DC power outlet.
CAUTION: Do not use the unit to run appliances that draw more than 20A DC.
NOTE: Extended operation of a 12V DC device may result in excessive battery drain. Recharge the unit
immediately after unplugging the 12V DC device.
Estimated run-times
APPLIANCE TYPE
Cell phone, fluorescent light
Radio, fan, depth finder
Camcorder
Electrical tool
Electric cooler
Car vacuum, air compressor
NOTE: Actual time may vary. Times are based on the internal battery being fully charged.
FOR MODELS WITH AN AIR COMPRESSOR
5.5
WARNING. Read the instructions of the product being inflated before using the compressor. Avoid
overinflation; do not exceed the manufacturer's recommended pressures. Do not leave the air
compressor unattended during use.
NOTE: Wrap cleats are provided for convenient storage of the air compressor hose. Wrap the hose
around these cleats when the hose is not in use.
1. Ensure the battery clips are securely on the storage holders.
2. Remove the air compressor hose from the storage cleats.
3. Connect the adapter to the valve stem by threading it onto the end. If necessary, use one of the
additional adaptors.
4. Press the air compressor power switch to turn ON and inflate to the desired pressure or fullness (refer
to the gauge next to the switch).
5. When the desired pressure is reached, press the air compressor power switch to turn OFF and remove
the connector from the valve stem.
6. Allow unit to cool.
7. Recharge the unit before storing.
NOTE: The air compressor is rated for 150 PSI.
Estimated time for inflating
Vehicle tires 13-16"
Bike tires
Sports balls
These times are approximate. Use the air compressor gauge
to ensure the proper pressure has been reached. Do not overinflate.
EST WATTAGE
4 watts
9 watts
15 watts
24 watts
48 watts
80 watts
6-24 minutes
1-3 minutes
30 seconds
• 8 •
APPROX. USAGE
34 hrs
14 hrs
7 hrs
5 hrs
2 hours
1.8 hrs
Publicité
