Vega FLEX 83 Mise En Service page 80

12 Annexe
Diagnostics
General Information
Liste des paramètres
Le tableau suivant offre un aperçu des paramètres utilisés.
FF desciptor
PRIMARY_VALUE
PRIMARY_VALUE_UNIT
SECONDARY_VALUE_1
SECONDARY_VALUE_1_
UNIT
SECONDARY_VALUE_2
FILL_HEIGHT_VALUE
FILL_HEIGHT_VALUE_UNIT
CONST_VALUE
SECONDARY_VALUE_1_
TYPE
SECONDARY_VALUE_2_
TYPE
FILL_HEIGHT_VALUE_Type
DIAGNOSIS
DIAG_MASK_1
DIAG_OUT_1
DIAG_MASK_2
DIAG_OUT_2
DEVICE_IDENTIFICATION
DEVICE_NAME
IS-SPARE_ELECTRONICS
80
Standard
Advanced
Performance
Function Blocks Instantiable
LAS (Link Active Scheduler)
Master Capable
Number of VCRs (Virtual Communication Re-
lationships)
Description
PRIMARY_VALUE (Linearized value). This is the process va-
lue after min/max adjustment and Linearization with the status
of the transducer block. The unit is defined in " PRIMARY_VA-
LUE_UNIT"
Selected unit code for " PRIMARY_VALUE"
This is the measured value after min/max adjustment with
the status of the transducer block. The unit is defined in " SE-
CONDARY_VALUE_1_UNIT"
Selected unit code for " SECONDARY_VALUE_1"
This is the distance value (" sensor_value") with the status of
the transducer block. The unit is defined in " SECONDARY_VA-
LUE_2_UNIT"
Filling height. The unit is defined in " FILL_HEIGHT_VALUE_
UNIT"
Filling height unit
Constant value
Secondary value 1 type
Secondary value 2 type
Filling height value type
AITB Diagnosis
Manufacturer ID, device type, bus type ID, measurement prin-
ciple, serial number, DTM ID, device revision
Device name
Device name
Yes
Yes
No
No
Yes
Yes
24
Unit
VEGAFLEX 83 • Foundation Fieldbus