Preliminary Information - AERMEC VMF-E2D Manuel D'utilisation Et D'installation

INSTALLATION
WARNING: VMF-E2D is designed
for indoor use.
WARNING: check that the power supply
is disconnected before carrying out any
procedures on the unit.
WARNING: before carrying out any
work, put the proper individual
protection equipment on.
WARNING: the device must be
installed in compliance with national
plant engineering rules.
WARNING: the electrical connections,
plus the installation of fan coils and

Preliminary information

The installation of additional VMF-E2D
and any other connected accessories
must be performed before installing the
unit.
Accessory VMF-E2D must be installed on
the same side of coil connections by
replacing the side panel installed on the
machine with the one supplied with the
accessory.
In the box VMF-E2D are 2 side pieces
Installation with the attacks on the
right of the battery
When installed with the attacks on the
right of the battery, the battery must
be turned from its original position as
shown in the section of the manual
unit and thermostat housing should be
moved from the right side to the left
side.
WA R N I N G: FO R I N STA L L AT I O N
MODELS OMNIA ULI:
The control panel (side element and PCB)
and the box hermostat must be installed
on the same side of the unit opposite to
the water connections side.
relevant accessories, should only be
performed by a technician with the
necessary technical and professional
expertise to install, modify, extend and
maintain systems, and who is able to
check the systems for purposes of safety
and correct operation (in this manual
such technicians will be indicated with
the general term "personnel with
specific technical skills").
In the specific case of electrical wirings,
the following must be checked:
- measurement of the electrical system
insulation strength.
- continuity of the protection wires
(left and right) to set up for the
implementation of the electronic board.
The installation of the control panel
VMF-E2D involves the replacement of
a lateral element of the unit with one
of the two lateral elements dedicated
supplied with the accessory. The
installer must use only the lateral
element which must be matched to the
electronic card.
In case of installation with water valve to
Cable connectors of the air temperature
s e n s o r ( L = 2 3 0 0 m m ) a n d t h e
microswitch on the head (Change over),
should be brought to the left side and
connected to the thermostat.
The water temperature sensor must be
removed from its seat in the battery
and if you do not intend to apply
the accessory water valve will be
WARNING: Install a device, main
switch, or electric plug so you can fully
disconnect the device from the power
supply.
The essential indications to install the
device correctly are given here.
The installer's experience will be
necessary however, to perfect all the
operations in accordance with the
specific requirements.
The assembly site must be chosen
in such a way that the maximum and
minimum ambient temperature limits
are respected 0-45°C (<85% R.H.).
replace the water temperature sensor
series (L = 500mm) with the probe
accessory VMF-SW (L = 2500mm) of
adequate length to be fixed to the water
inlet pipe downstream of the valve and
connected to the thermostat card on the
opposite side.
reassembled on the other side of the
battery. When installed with the water
valve to replace the water temperature
sensor series with the probe accessory
VMF-SW.
AVMFE2D 1504 - 6795755_01
13