Esc And Transmitter Calibration; Programming With The Smart Programmer Box; 160A Programmable Options - Horizon Hobby PROBOAT IMPULSE 32 Manuel De L'utilisateur

EN

ESC and Transmitter Calibration

1. Begin with the transmitter and receiver binding complete.
2. Set your transmitter's throttle channel to 100% travel and
trim to neutral.
3. Turn on your transmitter and connect a battery to the ESC but
don't power it on.
4. Press and hold the Set button while turning on the ESC.
When the red LED begins to flash, release the Set button.
The ESC will enter programming mode if the button is
pressed for more than three seconds.
TIP: The red LED should be flashing when the ESC enters
calibration mode. If the green LED is flashing the ESC is in
programming mode.

Programming with the SMART Programmer Box

1. Unplug the fan and connect the programming lead to the
fan port.
2. Connect a battery to the ESC.
3. Power on the box and select the parameter with the
SELECT button.

160A Programmable Options

Programmable Items
Running Mode
LiPo Cells
Cutoff Voltage
Timing (degree)
Motor Rotation
*The blacked out cells with white text are the default settings.
12
1 2
Forward Only Forward/Reverse
Auto Calc. 3S
Disabled 2.8V/Cell
0.0 3.75
Clockwise Counterclockwise
5. Leave the throttle trigger at the neutral position, then press
and release the Set button. The red LED will stop flashing, the
green LED will flash one time and the motor will make a tone
to indicate the neutral position has been accepted.
6. Hold the throttle trigger at the full throttle position then
press and release the Set button. The green LED will flash
twice and the motor will make two tones to indicate the
full throttle position has been accepted.
7. Hold the throttle trigger at the full brake position then press
and release the Set button. The green LED will flash three
times and the motor will make three tones to indicate the
full brake position has been accepted.
The motor will operate normally after calibration is completed.
4. Change the values of the selected parameter with the EDIT
button
5. Press the SAVE button to save the changes. The ESC
requires a power cycle to implement the saved changes.
Parameter Options
3 4
4S 5S
3.0V/Cell 3.2V/Cell 3.4V/Cell
7 .5 11.25
Impulse 32-Inch Brushless 6S Deep V
5 6 7
6S 7S 8S
15.0 18.75 22.5 26.25
8 9