Publicité
Les langues disponibles
Les langues disponibles
en-us Rinse Aid
,
Rinse Aid
T o achieve proper drying, always use
R i n s e A i d
a liquid rinse aid, even if your
detergent contains a rinse aid or
drying additive.
The dishwasher indicates low
Note:
rinse aid by turning on the Rinse Aid
indicator. If this indicator lights up,
you need to refill the rinse aid
dispenser 1b by following the
directions below.
Adding rinse aid
NOTICE
To avoid oversudsing or clogging, do
not overfill the rinse aid
dispenser 1b. Wipe up any spills
with a damp cloth.
Open the rinse aid dispenser 1b
1.
by pressing on the latch of the lid
and pull it open.
Add liquid rinse aid to the
2.
dispenser 1b until it is full. Do
not overfill. Avoid spilling into air
vent hole.
14
Close the lid. Lid must be fully
3.
closed until it clicks in order to
seal.
Wipe up any excess rinse aid that
4.
may have puddled when the
dispenser reservoir is full.
The indicator light will go out a few
moments after the dishwasher door
is shut.
For easier pouring, remove lid
Tip:
from the rinse aid bottle.
NOTICE
Do not fill the rinse aid dispenser 1b
with detergent. Doing so will damage
the dishwasher.
Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set from §:‹‹ to §:‹‡. The
factory setting is §:‹†.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
Setting
Amount
dispenser is OFF
§:‹‹
lowest setting
§:‹‚
low setting
§:‹ƒ
Publicité
