Publicité
INSTALLATION
Hob installation
Prepare the hole in the worktop and fix the induction hob as shown according to the dimensions
indicated (see 'Built in dimensions').
Non-flush installation
1. Before inserting the appliance into the hole in the kitchen worktop, the supplied foam gasket
must be attached to the lower side of the glass.
CAUTION! Do not install the appliance without the foam gasket!
•
Warning! The gasket should be attached to the appliance in the following way:
Remove the protective film from the gasket.
▷
Attach the gasket to the lower side approximately A=2-3 mm from the edge. The gasket
▷
must be attached along the entire length and should not overlap at the corners.
A
Flush installation
1. Lay in silicone sealant flush with the hole where the milling was done and set the hob in place.
EN 10
05
A
Kit
Tape
Tape
Tape
Publicité
