Publicité
Les langues disponibles
Les langues disponibles
Assembling the cutting
equipment
WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
Fitting a trimmer guard and Superauto II
1" trimmer head
•
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the guard onto the fitting on the
shaft and secure it with the bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
To fit the trimmer head, first separate the two halves
(see diagram). Proceed as follows:
•
Insert a finger into the centre hole of the cover (I) while
grasping the cover with your other fingers. Using the
index finger and thumb of your other hand, release the
two catches (J) that engage in the cut-outs in the
bottom half (K). Pull apart the trimmer head, grasping
the cover firmly.
38 – English
ASSEMBLY
K
G
K
F
B
I
C
J
I
A
•
Place the cover (I) and the support flange (F) on the
output shaft. Ensure that the drive disc's guide locates
correctly in the cover's centre hole.
•
Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in
the tool kit. Hold the shaft of the spanner as close to
the blade guard as possible. To tighten the nut, turn
the spanner in the opposite direction to the direction
of rotation (Caution! left-hand thread).
•
Fit the bottom half of the trimmer head (K) to the cover
(I) by pressing them together, with the cut-outs on the
bottom half aligned with the catches on the cover.
•
To dismantle, follow the instructions in the reverse
order.
Fitting other guards and cutting
attachments
•
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
A
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
B
C
A
Publicité
