BH FITNESS YH2100 Instructions De Montage Et Utilisation page 10

1. ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of its box and make
sure that all of the pieces are there
Fig.0.
STEP 1: Install the Front and Rear
Stabilizers
Fix the Front stabilizer (2) and Rear
stabilizer (3) to the Main frame (1) with
the Carriage bolts (7), Arc washers
(12) and Acorn nuts (10).
STEP 2: Install the Right and Left
Pedals
Secure the Left and Right Pedals
(17L/R) to the Crank (16) respectively,
viewed from
position.
Note: Both pedals are labeled L FOR
LEFT and R FOR RIGHT.
To tighten turn
COUNTERCLOCKWISE and the right
pedal CLOCKWISE.
STEP 3: Install the Handlebar Post
Connect the Sensor wire (22) to the
Connective wire (21) coming out from
the Handlebar post (4).
Put the end of Tension controller (19)
into the spring hook of Tension cable
(20), pull the resistance cable of
Tension controller (19) up and force it
into the gap of metal bracket of
Tension cable (20).
Finally, insert the Handlebar post (4)
to the Main frame (1) and secure with
the Allen bolts (8) and Arc washer
(13).
the rider's seated
the left
Ensure that ALL bolts and washers
are in place and partially threaded in
before completely tightening any ONE
bolt.
STEP 4: Install the Handlebar
Fit the Pulse sensor wires (23)
through the hole of Handlebar post
(4), and then pull out from top of the
Handlebar post (4);
Fit the Handlebar (5) across the
Handlebar Post (4), secured in place
with the T-Knob (9), Handlebar Clamp
(24), Spacer (14) and Flat Washer
(18) as shown.
STEP 5: Install the computer
Connect the Pulse sensor wires (23)
and Connective wire (21) to the wires
coming out from the Computer (26),
and then attach the Computer (26) to
the Computer bracket.
STEP 6: Install the Saddle Post
Place the Saddle (27) over the
pedal
Horizontal Seat Post (38), secured in
place with the Locking Nut under the
Saddle.
Attach the Horizontal Seat Post (38)
with Saddle on it to the Saddle Post
(6), and secured with the Knob Nut
(11), Flat Washer (15) and U-Shaped
Slider (29).
Insert the Seat Post (6) into the Main
Section, adjust to a proper position,
secure in place with the Pop-pin Knob
(28) as shown.
10