Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Appliance
Note: The appliance is heavy. It is advisable to insert
it together with a second person.
NOTICE: Before installing the oven, be sure to verify
the cabinet dimensions and electrical connections.
Mount to Cabinet
Use the included retaining plate and two screws to
fasten on the side bottom of the hinge side in the
installation cabinet. Mark the screw midpoint, the
retaining plate must be positioned precisely.
Depending on the installation situation, on partition
floor or heating drawer WS4.., turn the retaining plate
by 180°. When pushed into the cupboard, the
appliance snaps into the retaining plate.
Secure the appliance against tilting in the cupboard if
there is not intermediate shelf above the appliance:
fasten two commercially available brackets on both
sides inside the cupboard (at 17
3
/
" (5 mm) above appliance height).
16
/
" (450 mm) deep,
3
4
1
Push the appliance fully into the kitchen unit.
Route the Combi-steam oven's connecting cable
and supply and drain water hoses to the
connection points on the rear left in the kitchen
unit.
Do not kink or jam connecting cables and hoses
or route them over sharp edges.
2
Align the appliance in the center.
An air gap of
3
/
" (5 mm) is required between the
16
appliance and adjoining furniture frontages.
9
Publicité
Table des Matières
