Crivit 326472 1904 Notice D'utilisation page 7

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following instructions for
use carefully.
Use the product only as described and only
for the given areas of application. Store these
instructions for use carefully. When passing the
product on to third parties, please also hand
over all accompanying documents.
Package contents
1 x chain whip (1)
1 x bearing spanner, e.g. for Hollowtech II,
compatible bearing shells (2)
1 x pedal wrench (15mm) (3)
1 x Allen key, 8mm (4)
1 x attachment holder/puller (5)
6 x Allen key 2 / 2.5 / 3 / 4 / 5 / 6mm
(4 /5 / 6mm with spherical head) (6)
3 x tyre lever (7)
1 x chain rivet tool for 6 - 10 gears (8)
1 x spoke spanner (9/10/11/12/13/
14/2x 15) (9)
1 x square crank puller (10)
1 x star cap tool for Hollowtech II chainsets (11)
1 x Cassette puller with guide pin for Shimano
HG (12)
1 x T25 Torx spanner (13)
1 x tool case
1 x instructions for use
Technical Data
Dimensions: approx. 28.5 x 21.3 x 6cm
(W x H x D)
Weight: approx. 1850g
Date of manufacture (month/year):
11/2019
Intended use
This item is a bicycle tool case for private use.
The item is intended for simple repairs and does
not replace specialist tools.
Safety Instructions
Life-threatening hazard!
• Never leave children unattended with the
packing materials. There is a risk of suffoca-
tion!
Risk of injury!
• The item contains sharp components. Be care-
ful not to injure yourself!
• Pay special attention to your fingers when
flipping the case open and shut. There is a risk
of injury from crushing.
• Check the item for damage or wear before
each use.
• Caution! Not suitable for children under 36
months. Risk of suffocation and choking due to
small parts that can be swallowed or inhaled!
Use
Removing the cassette (Fig. E)
1. Remove the back wheel of your bicycle. To do
this, undo the quick release or alternatively,
undo the nuts.
2. Put the cassette removal tool (12) into the
closure ring of the cassette (Fig. E).
Note: Take note that the removal tool must fit
your cassette. Depending on the manufacturer,
you may possibly require a different removal
tool each time.
3. Put the chain whip in parallel around the
sprockets of the cassette.
4. Insert the Allen key (4) with the attachment (5)
into the cassette removal tool (12) and loosen
the closure ring.
5. First unscrew the closure ring. Then remove
the cassette.
Removing the pedals (Fig. C)
1. Unscrew the left pedal in a clockwise direc-
tion using the pedal spanner (3).
2. Unscrew the right pedal in an anti-clockwise
direction using the pedal spanner (3).
Note: Grease the pedal thread before reinstat-
ing the pedals.
GB/IE 7