SilverCrest SPPD 20000 A1 Instructions D'utilisation Et Consignes De Sécurité page 32

P Operation and use
Charging the power bank
The built-in rechargeable battery must be fully charged before
using the product.
To charge the power bank
an output voltage of 5 V and an output current of at least
3 A.
ATTENTION! The power bank should not be charged
from a PC or notebook.
Connect the USB type C plug of the USB cable
USB type C input port
Connect the other end of the USB cable
A) to a USB power supply (not included in the scope of
delivery) (see fig. A).
The LED indicator for battery capacity
approximate charge level of the internal battery via 4
LED lights. After approx. 30 seconds the LED indicator
goes out, you can light up the LED indicator
pressing the ON / OFF button
LED indicator
1 LED flash
1 LED light up, 1 LED flash 25 - 50 %
2 LED light up, 1 LED flash 50 - 75 %
3 LED light up, 1 LED flash 75 - 100 %
4 LED light up
GB/IE 32
6
of the power bank
2
status Power bank capacity level
9
0 - 25 %
100%
only use power supplies with
7
shows you the
9
5 .
with the
7
.
6
(USB Type
9
9 again by