S&P RESPIRO 100 N Mode D'emploi page 32

MAINTENANCE
All the device's maintenance operations are exclusively aimed at qualified staff.
EN
Make sure that the room's mains network is disconnected before carrying out maintenance operations.
Once installed, the product's components should be arranged as shown in the above image.
1) INDICATION OF MAINTENANCE PERIOD
We advise cleaning the filters (8) and the ceramic exchanger (7) every 3 months.
We advise changing the filters every 2 years. Contact your dealer for delivery of replacement filters.
1a) RESPIRO 100 N / RESPIRO 150 N
This version does not have an alarm for cleaning/replacement of filters.
1b) RESPIRO 100 RD N / RESPIRO 150 RD N
Every 2000 hours of operation the indicator light at the bottom right will emit a continuous red light signal. During the
alarm, each remote control, except for the filter reset combination, will be disabled. The product will continue to operate
with the last command received.
Clean the exchanger and the filters as specified in the paragraph. Replace the filters when necessary.
2) CLEANING OF FILTERS AND EXCHANGER
Remove the main unit (1+2+3) from the wall using a flat-head screwdriver to actuate the hook placed bottom centre of
the unit as shown below.
Once the functioning unit has been unfastened from the wall (4i) extract it with your hands, pulling hard as in the image
below:
32