To remove the trimmer head
1. Put the locking pin (C) in the hole to lock the shaft.
2. Turn the trimmer head (H) clockwise to remove it.
Introduction
WARNING:
safety chapter before you use the product.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 31)
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
Work position
•
Hold the product with 2 hands.
•
Hold the product on the right side of your body.
•
Keep the cutting attachment below waist level.
•
Keep body parts away from the hot surfaces.
•
Keep body parts away from the cutting attachment.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
•
Do an overhaul inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
•
Examine the support flange for cracks. Replace the
support flange if it is damaged.
(Fig. 32)
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they have been
hit or if they have cracks.
14
Operation
Read and understand the
Only use Husqvarna
If the battery does not
3. Remove the drive disc (B) from the output shaft.
(Fig. 30)
(Fig. 33)
To start the product
1. Push and hold the start button until the green LED
comes on. (Fig. 34)
2. Use the power trigger to control the speed.
To limit the maximum speed with the
mode button
The product has a mode button. With the the mode
button the operator can limit the maximum speed. The
mode button has 3 speed levels. A lower level increases
the time of operation for the product. Use level 1 and
level 2 if the operation does not require full speed/full
power. If the operation condition requires full speed/full
power, use level 3. Do not use a higher level than
necessary for the operation.
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on. (Fig. 35)
2. Push the mode button again to choose the next
speed level.
Automatic shutdown function
The product is equipped with a shutdown function that
deactivates the product if it is not used.
Grass trimming with a trimmer head
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. (Fig. 36) Do not push the grass
trimmer line into the grass.
2. Use 80 % speed when you cut grass near objects.
(Fig. 37)
To cut the grass
1. Make sure that the grass trimmer line is parallel to
the ground when you cut. (Fig. 38)
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously, it can cause damage to the trimmer
head.
4. Use full speed when you move the product from side
to side to cut grass. (Fig. 39) Make sure that the
grass trimmer line is parallel to the ground.
1857 - 006 - 17.04.2024