Bosch BBH3 Serie Mode D'emploi page 52

Controlling the suction level
5
Fig.
Slide the sliding switch into the required position in
order to set the suction power:
Position 1
•
Vacuuming with the electric brush switched on.
For routine cleaning tasks on all surfaces.
7KH DSSOLDQFH DFKLHYHV WKH PD[LPXP UXQ WLPH DW
this level.
Position 2
•
Vacuuming with the electric brush switched on.
For stubborn cleaning tasks on all surfaces (carpets,
LQ SDUWLFXODU 
The appliance achieves a shorter runtime at this le-
vel.
Runtime
Like every other Li-Ion battery the battery is subject
to natural wear as well. That means the battery ca-
pacity and thus runtime decrease over time. This is a
natural aging process and not the result of a material/
production failure or a product defect.
BBH3/BCH3
25,2V
On normal mode Up to 55 min.
with electrical
nozzle for normal
cleaning tasks
Turbo mode Up to 20 min.
with electrical
ÁRRU QR]]OH RU
hand-held for de-
manding cleaning
tasks
6
Fig.
During short pauses in vacuuming, the appliance can
•
be left standing anywhere in the room. To do this, tilt
the vacuum cleaner forwards slightly in the direction
of the nozzle.
!
Caution: When the appliance is left standing, it
must be switched off because, if the brush is
turning while the appliance is standing still, it could
Using the hand-held cordless vacuum
cleaner
7
Fig.
Unlock the hand-held cordless vacuum cleaner by
•
pressing the release button and remove it from the
hand stick.
52
1
2
BBH3/BCH3
21,6V
Up to 50 min.
Up to 18 min.
Vacuuming with accessories
8
Fig. Crevice nozzle
)RU YDFXXPLQJ LQ GLIÀFXOWWRUHDFK SODFHV DQG RYHU-
•
head.
Open the accessory holder using the recessed grip
•
and remove the crevice nozzle. Place it on the air
intake opening of the cordless handheld vacuum
cleaner and click into place.
7KH FUHYLFH QR]]OH FDQ EH H[WHQGHG DV UHTXLUHG 7R
•
do this, press the unlock button, pull out the crevice
nozzle and engage it in the end position.
After use, push the crevice nozzle together again,
•
place it in the accessory holder and close the holder.
9
Fig. Combination nozzle
Combination nozzle with furniture brush and uphols-
•
tery nozzle for vacuuming window frames, cup-
boards, furniture, etc.
Open the accessory compartment and remove the
•
combination nozzle. Place it on the air intake ope-
ning of the upright vacuum cleaner and click into
place.
The furniture brush attachment can be pushed to the
•
side. The upholstery nozzle is located underneath.
The combination nozzle can also be placed on the tip
•
of the crevice nozzle.
After use, place the combination nozzle back in the
•
accessory compartment for storage, close the ac-
cessory compartment, clicking it into place.
Charging the hand-held cordless vacuum cleaner
10
Fig.
To charge the hand-held cordless vacuum cleaner,
•
insert it into the hand stick and lock into place. Make
sure that it is seated correctly.
After using the appliance
11
Fig.
Switch off the appliance after vacuuming.
•
Emptying the dust container
In order to achieve the best possible vacuuming re-
sults, the dust container should be emptied after every
use or, at the latest, when dust at one point in the dust
container has reached the marking.
:H UHFRPPHQG WKDW \RX QRW ÀOO WKH GXVW FRQWDLQHU EH\-
ond the marking, as this leads to considerable soiling
RI WKH ÀOWHU
12
Fig.
Remove the hand-held cordless vacuum cleaner
•
from the hand stick.
Using the release button, unlock the dust container
•
and remove it from the motor unit.
* Depending on model
7
Fig.