Husqvarna TS300E Manuel D'utilisation Et D'entretien page 30

PREFACE TO THE MANUAL
Before leaving our factory every machine passes an exacting inspection programme in which everything is
checked minutely.
Following the instructions will ensure that your machine gives long service, in normal operating conditions.
The user advice and spare parts mentioned in this document are given as an indication, and do not consti-
tute an undertaking. No warrantee will be granted in the event of errors or omissions, or for damage occur-
ring during delivery, or caused by the design or use of the machine. We are very concerned about the qua-
lity of our products and we reserve the right to make any technical modifications to improve them, without
warning.
This document will:
• provide the user with: information about the machine
• information about its possible uses
• prevent accidents due to unsuitable use, by an untrained person, during maintenance, repairs, ove-
rhauls, handling or transport
• improve the reliability and durability of the machine
• ensure correct use, regular maintenance, and fast fault finding in order to reduce repair costs and
downtime.
The manual should always be available at the place of work.
It should be read and used by any person installing or using the machine.
The obligatory technical regulations in force in the country where the machine is used must also
be adhered to for maximum safety.
GENERAL SAFETY INSTRUCTIONS
The Equipment fulfills the requirements in EN61000-3-11 and is subject for conditional connection
to the mains. It may be connected in consultation with the supply authority. The equipment will
only be connected to the mains supply with impedance lower than 0,49 Ohm. The system
impedance at the interface point may be obtained from the supply authority
If the mains supply has higher system impedance, short voltage dips may appear when the
equipment is started. This may influence the operation of other apparatuses, e.g flickering lights.
The use of symbols on machines (in color) and in the manual identify advice concerning your safety.
!
WARNING
OBLIGATION
WARNING
INTERDICTION
INDICATION
The manufacturer declines any responsibility resulting from improper use, or modifications.
13
Danger symbol
Blue background, white marking : obligatory safety
+ red marking : movement forbidden
Black triangle and marking on a yellow background : danger if not
adhered to. Risk of injury to the user or third parties, with possibility
of damage top the machine or the tool.
Red circle with or without bar : use or presence prohibited.
Information - Instruction: special instructions concerning use and ins-
pection.