Publicité
Les langues disponibles
Les langues disponibles
WARNING:
Always use an air fitting that discharges all the com-
pressed air in the tool at the time the fitting or female
quick connector is disconnected. Using an air fitting
that does not discharge the compressed air could cause
unintended operation and serious personal injury.
WARNING:
Do not climb rigging or scaffolding while carrying a tool
that is connected to an air hose. Doing so could result in
serious personal injury.
Connect the tool to the air supply with a 1/4 in. female quick
connector.
WARNING:
The headless pinner is capable of driving a fastener
without making contact with a workpiece. Always point
the tool away from yourself or others and always direct
the fastener toward the work surface before pulling the
trigger. Failure to do so could result in possible serious
personal injury.
LOADING THE TOOL WITH FASTENERS
See Figures 3 - 6, pages 12 - 13.
WARNING:
The tool's driving mechanism may cycle when the tool
is first connected to the air supply. Always connect the
tool to the air supply before loading fasteners to prevent
injury from unintended cycling. Always make sure the
tool's magazine is empty at the beginning of each work
session, before connecting to an air supply.
WARNING:
Keep the tool pointed away from yourself and others
when loading fasteners. Failure to do so could result in
possible serious personal injury.
WARNING:
Use only the fasteners recommended for use with this
tool. The use of any other fasteners can result in tool
malfunction, leading to serious injuries.
OPERATION
WARNING:
When loading fasteners, do not pull the dual actuation
trigger system, as accidental actuation will occur and
could cause serious personal injury.
Connect the tool to the air supply.
Select the fastener size you are loading using the nail
length selector.
Turn the tool so the magazine faces up, then depress the
latch and slide the magazine open.
Make sure the secondary trigger has locked out the pri-
mary trigger.
Insert the fasteners, pointed end up, into the groove in
the nail track as shown. Fasteners should sit securely in
the nail track.
NOTE: Your fasteners may be marked with an arrow,
indicating the pointed end.
Slide the magazine to close. Make sure the latch is secure.
REMOVING FASTENERS FROM THE TOOL
Disconnect the tool from the air supply.
WARNING:
Disconnect the tool from the air supply before remov-
ing fasteners. Failure to do so could result in serious
personal injury.
To remove a strip of fasteners from the tool, depress the
latch located at the rear of the magazine and slide the
magazine open.
Remove the fasteners.
DRIVING A FASTENER
See Figures 7 - 8, page 13.
WARNING:
Never wedge or hold back the secondary trigger during
operation of the tool. Doing so could result in possible
serious injury.
WARNING:
Do not pull the dual actuation trigger system unless the
nose of the pinner is pressed against the work surface.
Accidental actuation will occur and could cause serious
personal injury.
8 — English
Publicité
