R.G.V. SBSI 30 Notice D'utilisation Et Entretien page 12

Professional use: The supplier restricts himself to repair or replace all components should have constructions faults in the first 12 months
from the date of installation and however not later than 18 months from the shipment date.
Components subjected to normal consumption such as Fuses, Welding bar gasket, Welding bar resistance, Welding bar cover or Vacuum
Chamber Gasket are excluded from warranty. The costumer must indicate to the supplier, in order du benefit from the warranty, the faults
pointing out, the serial number of the machine, the purchase date (from invoice), and furthermore he will have to send the faulty part at his
charges for reparation or replacement. The supplier fulfils completely his warranty obligations by the reparation or replacement of the faulty
piece. If reparation is requested where the machine is installed, all charges regarding, labor, trip and hotel fees of the technicians will be
entirely at the purchaser charges. The damage due to an inappropriate use, missed maintenance, tampering are not included in the
warranty.
WARNING AND RULES
Read carefully all instructions before using the machine, taking particular care of the
paragraphs with the safety and danger symbols. Remove the plug before all
maintenance and cleaning operations
WARNING FOR USE
The manufacturer declines all responsibility in case of improper use of the machine
Check the supply cord periodically, if damaged replace it with a supply cord of the
-
same type as the one provided; its replacement must be done by qualified technician
in order to avoid a
Do not immerse the machine in water or other liquids for cleaning
-
Do not remove the plug from the socket gripping the power cord
-
Do not use extension cables
-
Do not use the machine with wet hands or bare feet
-
Disconnect the plug from the socket when not in use and before cleaning or
-
maintenance in such a way that an operator located near the machine can check that
the plug remains removed
TRANSPORT – HANDLING – STORAGE
The machine is pace in a cardboard box with protection plugs.
The package is proper to travel by all means of transport.
Stacking cartons is suggested for a maximum of 5 pieces.
The package must be stored in a dry and no dust place. When on pallets, handling by lifters is suggested.
UNPACKING
Open the cardboard box, take off the machine and place on a flat support.
DIRECTIVE 2002/96/CEE
At the end of his working life the product must not be disposed as urban waste. It must be taken to a special local authority
differentiated waste collection centre or to a dealer providing t his service.
INSTALLATION
The surface where the machine has to be installed must take into consideration the support dimensions. Furthermore, it must be smooth,
dry, strong and with an height from the ground of about 80 cm. and with around the necessary space for use and maintenance.
Environmental conditions:
Minimum temperature +10° - Max. temperature + 30°
Minimum moisture 30% - Max. moisture 80%
ELECTRICAL CONNECTION
Preliminary controls
Before connecting the machine to a socket, take care:
Make sure the socket is provided with a ground protection
-
Make sure that the voltage and frequency of supply correspond to those indicated on
-
the data plate of the machine
hazard.