BH FITNESS NC19 Instructions De Montage Et Utilisation page 21

1.- ASSEMBLY INSTRUCTIONS.-
1. Take the unit out of its box and make
sure that all of the pieces are there:
ATTENTION: The assistance of a
second person is recommended
when assembling this machine
Fig.1 Parts list
(1) Monitor.
(5) Main post.
(9) Handlebar.
(15) Bracket cover.
(19) Handlebar R cover.
(22) Right focus bar.
(26) Handlebar R cover.
(28) Right upper focus bar.
(32) Handlebar post cover.
(34) Main frame.
(51) Right foot bar.
(52) Lower handlebar cover.
(61) Lower handlebar cover.
(63) Pedal cover.
(64) Pedal R.
(65) Right footrest.
(80) Middle and rear stabilizer.
(113) Left foot bar.
(114) Left footrest.
(115) Pedal L.
(116) Lower handlebar cover.
(117) Left focus bar.
(118) Lower handlebar cover.
(119) Handlebar L cover.
(120) Handlebar L cover.
(121) Left upper focus bar.
(122) Axis.
(124) Front stabilizer.
(125) Front stabilizer cover.
(131) Bracket cover.
(138) Adapter.
Fig.2 Screws and fasteners.
(6) Washer D8.5x9x2.
(7) Washer D8.5x13.5x2.5.
(8) Screw M-8x20.
(13) Screw M-8x16.
(14) Screw M-5x16.
(18) Washer D17.5x25x0.3.
(20) Nut M-8.
(21) Washer D8.5x9x2.
(24) Washer D8.5x25.
(25) Screw M-8x20.
(27) Screw ST2.9x8.
(31) Screw M-8x40.
(36) Washer D20.5x30x0.3.
(54) Screw M-8x55.
(62) Screw ST2.9x16.
(74) Pedal connector.
(139) Washer D5.5.
2.- FITTING THE STABILISER
BARS.-
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
Bring the front stabilizer bar with
wheels (124) to the main body (34)
positioning the wheels at the front of
the unit, Fig.3, Insert the screws (8)
and washers (6), (7) and tighten
securely. Place the stabilizer cover
(125) and insert the screws (14).
Bring the middle stabilizer bar (80) to
the main body (34). Insert the screws
(8) and washers (6), (7) and tighten,
Fig.4.
IMPORTANT: It is advisable to
retighten these screws after one
month of using the machine.
3.- FITTING THE MAIN POST.-
Take the main post (5) and insert the
bottom post cover (32). Bring the main
post (5) up to boss on the main body
(34), Fig.5, connect the terminals.
Slip the main post (5) over the boss on
the main body (34), Fig.5, making sure
not to snag any of the cables.
Refit the screws (8) and the washers
(7), (21), (6) and tighten securely.
21