Télécharger Imprimer la page

Shop-Vac SL14-600C Manuel D'instructions page 11

Publicité

Les langues disponibles

Les langues disponibles

AUTOMATIC SUCTION
SHUT OFF
48. The vacuum is equipped with an automatic suction
shut-off that operates when picking up liquids. As the
level of the liquid rises in the tank, an internal float rises
until it seats itself against a seal at the intake of the
motor, shutting off suction. When this happens, the
motor will develop a higher than normal pitch noise and
the suction is drastically reduced. If this occurs, turn
unit off immediately. Failure to turn unit off after float
rises and shuts off suction will result in extensive
damage to the motor. To continue use, empty the liquid
waste from the tank as outlined in the previous
section.
NOTE: IF ACCIDENTALLY TIPPED OVER, THE
VACUUM COULD LOSE SUCTION. IF THIS OCCURS,
TURN UNIT OFF AND PLACE VAC IN UPRIGHT
POSITION. THIS WILL ALLOW THE FLOAT TO RETURN
TO ITS NORMAL POSITION, AND YOU WILL BE ABLE
TO CONTINUE OPERATION.
TROUBLESHOOTING
Before doing any work on your vacuum, turn the unit off and disconnect the plug from the wall outlet.
PROBLEM
CAUSE
Loss of suction
Clogged filter
wet pick up
Full tank
Loss of suction
Full tank
dry pick up
Clogged filter
Full disposable filter bag
Loss of suction or misting
Full tank
during wet pick up
Saturated filter
LUBRICATION
49. No lubrication is necessary as the motor is equipped
with lifetime lubricated bearings.
STORAGE
50. Before storing your
vacuum cleaner the tank
should be emptied and
cleaned. The power cord can
be wrapped around the cord
can be wrapped around the
cord wraps provided on the
FIGURE 26
tank cover on rear of unit.
FIGURE 26.
51. Accessories may be stored in the tool holder. The
vacuum should be stored indoors.
SOLUTION
Clean filter, see steps 21 - 25 on page 6, 7 and steps
42 - 45 on pages 8, 9.
Empty tank, see step 47 on page 9.
Empty and clean tank.
Clean filter, see steps 21 - 25 on page 6, 7.
Remove bag or replace with new.
Drain and clean tank, see step 47 on page 9.
Clean filter, see step 38 on page 8.
PAGE 9

Publicité

loading