cecotec IRONHERO 3000 station Manuel D'instructions page 17

ENGLISH
The power indicator light (13) will start flashing.
- To restart the appliance, press the Power icon (3), the iron will start heating again.
- The appliance and the power indicator light (13) will automatically switch off if after 10
minutes no operation is performed. Hence, the user will have to press the Power icon to
restart the appliance.
4. CLEANING AND MAINTENANCE
The appliance has an automatic function that provides reminders to ensure regular descaling.
When the descaling process is required, the cleaning icon indicator light will light up and the
appliance will beep.
Warnings about the descaling function: to extend the lifetime of the appliance and to ensure
good steam ironing, the automatic descaling function should be used every two weeks. If the
water hardness in your city is high (i.e. limescale appears on the soleplate during ironing), you
should use the automatic descaling function more often.
1. Prepare a container with water.
2. Make sure the appliance is unplugged.
3. Fill the water tank with water, up to the MAX mark. Note: do not add vinegar or other
descaling agents to the water tank.
4. Insert the plug of the iron into a power socket, press the power icon (3) to switch on the
iron and turn the temperature knob (15) to any position.
5. Hold the iron over the container and press and hold the cleaning icon (5) until the indicator
light flashes and the appliance beeps briefly.
6. During the descaling process, you will hear short beeps and a pumping sound.
7. Wait about 2 minutes until the appliance completes the descaling process. Once the
descaling process is completed, the iron will stop beeping and the cleaning icon indicator
light will stop flashing.
8. Unplug the iron, wipe the soleplate with a cloth and put it back on the base.
9. The tank heats up during the descaling process, so you should wait approximately 5
minutes before touching it. Allow the appliance to cool down before storing it.
If necessary, you can repeat steps 1 to 9. Be sure to empty the tank before starting the descaling
process.
Note: during the descaling process, clean water may flow out of the soleplate if no limescale
has built up inside the iron. This is normal.
32
IRONHERO 3000 STATION
5. TROUBLESHOOTING
This section summarises some of the most common problems you may encounter.
If this does not solve the problem, contact the official Cecotec Technical Support Service.
Do not attempt to replace a defective power cable. Contact the official Cecotec Technical
Support Service.
Problem Possible cause
There is not enough water in
the tank.
The iron does not produce
steam
You are not pressing the
steam button.
The appliance emits a loud
Water tank is out of water.
pumping sound
ENGLISH
Solutions
Fill the water tank with
water, up to the MAX mark.
Press and hold the steam
button until steam comes
out. It can take up to 30
seconds for the steam to
come out.
Press and hold the steam
button until steam comes
out.
Fill the tank with water and
press the steam button
until the water pumping
sound is attenuated, and
steam comes out of the
soleplate.
33
IRONHERO 3000 STATION