cecotec IRONHERO 3000 station Manuel D'instructions page 16

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Steam hose
2. Steam hose storage compartment
3. Power icon
4. Modes icon (ECO STEAM MODE/CONTINUOUS STEAM)
5. Cleaning icon
6. Power cable
7. Heat-insulated bracket
8. Base
9. Soleplate
10. Lock button
11. Water tank handle
12. Water tank
13. Power indicator light
14. Steam button
15. Temperature knob
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
3. OPERATION
Using the appliance
- Press the lock button (10) to release the iron from the base.
- Press the Power icon for one second to switch the appliance on.
- Press and hold the Power icon for two seconds to switch the appliance off.
30
IRONHERO 3000 STATION
Filling up the water tank
- Make sure the iron is unplugged from the mains.
- Remove the water tank.
- Fill the water tank up to the MAX mark and put it back.
Steam ironing
Note: when using the appliance for the first time it is normal for the steam hose to have some
air in it, which will take about 30 seconds for the steam to come out. This is normal.
1. Fill the water tank as described in the section 'Filling up the water tank'.
2. Plug the iron to the mains.
- Steam ironing is only possible when heating has been completed (the indicator light will
remain steady green), otherwise, water may come out of the soleplate.
- Wait until the indicator light is no longer flashing to ensure that the soleplate is hot enough.
- Press the lock button (10) to release the iron from the base.
- The steam station will switch on by default to ECO Steam mode.
- To activate continuous steam, press the Modes icon (4). You can select between Continuous
steam mode and ECO Steam Mode. You can switch modes during ironing at any time by
pressing the same icon. Press and hold the steam button (14) to make the iron release
steam continuously. You do not need to press and hold the button (14) hard to release the
steam, a light press is sufficient.
Steam shot
- If you press the steam button (14) once, the iron will not release steam. You must press
it twice to activate the Steam shot function (the temperature knob must be in the "shot"
position for this function to operate).
- You can use the steam iron in upright position to remove creases in hanging clothes.
- Once finished ironing, place the iron upright or on the base.
- Unplug the iron from the mains. Pour off the excess water and allow the iron to cool.
Note: the pump is activated each time you press the steam button. That is why it is normal for
it to produce a slight rattling noise. When there is no water in the tank, the pump will make
more noise. Fill the water tank when this happens. When you have finished using the iron, do
not switch it off suddenly. Wait until the iron stops producing steam before switching it off,
otherwise, the next time you switch it on, steam or water droplets are likely to come out of the
soleplate.
Automatic switch-off mode
- To save energy, the appliance will automatically switch off if it is not used for 10 minutes.
ENGLISH
31
IRONHERO 3000 STATION