Hilti TE 30 A36 Manuel D'utilisation page 13

Technical data
Product generation
Rated voltage
Weight
Operation
Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶
Before inserting the battery, make sure that the product is switched off.
▶
Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
Inserting the battery
1.Push the battery into the battery holder until it engages with an audible click.
2.Check that the battery is seated securely.
Removing the battery
1.Press the release buttons on the battery.
2.Pull the battery out toward the rear.
Charging the battery
Make sure that the outer surfaces of the battery are clean and dry before inserting the battery
in the approved battery charger.
Read the operating instructions for the charger for further information about the charging
process.
▶
Use an approved charger to charge the battery.
Fitting the side handle
CAUTION
Risk of injury! Loss of control over the product.
▶
Check that the side handle is fitted correctly and tightened securely. Check that the clamping band
is engaged in the groove in the product.
1.Release the side handle clamping band by turning the handle grip.
2.Slide the side handle clamping band over the tool holder from the front and into the recess provided.
3.Set the side handle to the desired position.
4.Tighten the side handle clamping band by turning the handle grip.
Adjusting the depth gauge (optional)
1.Press the release button on the side handle.
2.Adjust the depth gauge to the desired drilling depth.
3.Release the release button.
4.Check that the side handle is securely attached.
Removing the chuck
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the operator.
▶
Remove the depth gauge from the product.
*2173713*
2
3
4
5
6
2173713
TE 30­A36
03
36 V
5.1 kg
7