Hilti TE 30 A36 Manuel D'utilisation page 12

Possible misuse
• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment.
ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite
direction. ATC detects this sudden pivoting movement of the product and switches the product off
immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
Motor protection system
The tool is equipped with a motor protection system. The system monitors current input and motor
temperature and thus prevents the tool from overheating.
If the motor is overloaded through application of excessive working pressure, the power tool's
performance drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the
tool and then allow it to run under no load for approx. 30 seconds.
Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The Li­ion battery state of charge is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED blinks, the power tool is not ready for
use.
4 LEDs blink, the power tool is not ready for
use.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5
seconds after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting
section.
Items supplied
Combihammer, side handle with depth gauge, operating instructions.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables.
Spare parts, consumables and accessories approved by Hilti for use with the product can be
found at your local Hilti Center or online at: www.hilti.com
6
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is completely
discharged.
The power tool is overloaded or has overheat-
ed.
2173713
*2173713*