Eurocave Modulotheque Notice De Montage page 12

B M ( 6)
AR ODULE MV
1
FASTENINGS
ax4
TOOL REQUIRED
SLIDING DRAWER
2
GUIDE
PARTS
Ax2
3
B
C
D
1
Ex4
Fx4
8
GB
SHELF
1
Shelf Support Strip Place the guides (A) in the shelf support strips.
Guide
A
B
2
Insert the sliding shelf (B).
3
Position the 4 shelf supports (E) in the shelf
support strips and set up the shelf (C).
C
E
GLASS HOLDER
1
Position the 4 rack support pins (F) on the
shelf support strips so as to create a level.
2
Position the glass rack (D) aligning it on the
F
racks. Tighten the 4 screws (a) lining up the rack
support pins holes (F) with those in the glass rack.
RACK
SUPPORT SHELF
SPIN
SUPPORT
STRIP
D
a
F
2
1
FASTENINGS
ax3
bx4
A
ex4
cx4
d
B
b
TOOLS REQUIRED
2
e
PARTS
A
3
B
C
D
a
E
D
F
5
R M (
ACK ODULE
ASSEMBLY
1
Secure the "magnum shelving unit" (A) to its
base plate (B) using the 4 screws (b) and by lining
up the various holes.
b
2
Remove the rack from the pedestal module,
nail the 4 parts (e) onto the 4 wedges, and
introduce the ready assembled unit in its place.
b
WARNING !
The Modulorack comes in a separate box.
3
b
Assemble the Modulorack (F) (following
directions in the box) and secure it onto the base
plate (B) using 4 screws (c) and by lining up the
holes in the Modulorack with the holes in the
base plate.
4
Position the upper cross piece (C) under the
rack of the basic module and position it on the
edge of the rack, securing it with 3 screws (a).
5
Position the drawer (D) at the required height.
From the inside, screw on the drawer 'handle'
F button with the screw provided (d).
c
4
B
C
d
N.B.:
- Oak panels (E) are supplied with the Rack module
to replace the original Modulorack ones.
- Module that fits into the basic module, only on the
base module (MV2)
8)
MV
9
GB