EIBENSTOCK EHR 20 S Notice Originale page 14

Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the lock-
on button
Switching-off: press the on/off switch and let it go off again
Attention!
Use the lock button only when using a stand. In the
case of any stopping of the machine or current
interruption the lock-on button has to be released
immediately by pressing the on/off switch, to prevent
an unintentional restarting of the machine (danger of
injuries)
The stirrer is equipped with an electronic switch.
With this switch the speed can be regulated according to the pressure on the
button. The use is only recommended for the starting and running out of the
machine to avoid material flying around. A permanent operation with reduced
speed will cause an overload because the motor then gets less cooling air and
therefor the machine will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the machine.
In case of failure, a repair has to be carried out by an authorised service
workshop.
14