Saber R50CC1715 Guide Des Produits page 6

Leak Testing Valves, Hoses and Regulator
1. Turn all control knobs to the OFF position.
2. Be sure regulator is tightly connected to LP cylinder.
3. Completely open LP cylinder valve by turning hand wheel
counterclockwise. If you hear a rushing sound, turn gas off
immediately. There is a major leak at the connection. Correct
before proceeding.
4. Brush soapy solution onto areas circled below, or other similar
fittings on your grill.
CAUTION
Putting out grease fires by closing the lid is not

possible. Grills are well ventilated for safety reasons.
Do not use water on a grease fire. Personal injury may

result. If a grease fire develops, turn knobs and LP
cylinder off.
Do not leave grill unattended while preheating or

burning off food residue on HI. If grill has not been
regularly cleaned, a grease fire can occur that may
damage the product.
WARNING
Turn controls and gas source or tank OFF when not
in use.
6
WARNING
For Safe Use of Your Grill and to avoid serious injury:

Do not let children operate or play near grill.

Keep grill area clear and free from materials that burn.

Do not block holes in sides or back of grill.

Check burner flames regularly.

Use grill only in well-ventilated space. NEVER use in

enclosed space such as carport, garage, porch,
covered patio, or under an overhead structure of any
kind.
Do not use charcoal or ceramic briquets in a gas grill.

Use grill at least 3 ft. from any wall or surface.

Maintain 10 ft. clearance to objects that can catch fire or
sources of ignition such as pilot lights on water heaters,
live electrical appliances, etc.
Apartment Dwellers:

Check with management to learn the requirements and

fire codes for using an LP gas grill in your apartment
complex. If allowed, use outside on the ground floor
with a three (3) foot clearance from walls or rails. Do
not use on or under balconies.
NEVER attempt to light burner with lid closed. A build-

up of non-ignited gas inside a closed grill is hazardous.
Never operate grill with LP cylinder out of correct

position specified in assembly instructions.
Always close LP cylinder valve and remove coupling nut

before moving LP cylinder from specified operation
position.