DeWalt GRABBER GR870 Guide D'utilisation page 8

FIG. 2 DIAMETER OF WORKPIECE
F
WIDTH OF SPACER BLOCK
FIG. 3
BLOCK
E
FIG. 4
Q
FORWARD
E
SPACER
BLOCK
CUT OFF
END
I
F
H
Vise Operation (Fig. 4)
The vise (F) has a quick-travel feature. To release the vise when it is
clamped tightly, turn the crank (H) counterclockwise one or two times
to remove clamping pressure. Lift vise lever (I) up. Pull crank assem-
bly out as far as desired. Vise may be pushed forward into work with-
out cranking. Lower vise lever (I) then tighten vise (F) on work by using
crank (H).
Fence Operation
CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or acces-
sories. Be sure the trigger switch is in the OFF position.
The fence (E) can be adjusted two ways: to change desired cutting
angle and to change spacing between the fence and vise.
TO CHANGE THE DESIRED CUTTING ANGLE (FIG. 5, 6)
Use the wrench provided to loosen (do not remove) the two fence
bolts (Q). Align the desired angle indicator line with the slot line (R) in
the base (D). Securely tighten both fence bolts before use.
FIG. 5
R
E
For more accurate square cuts, disconnect the power supply, loosen
the two fence bolts, push arm down until wheel extends into base. Place
a square against the wheel and adjust fence against the square.
Securely tighten both fence bolts before use.
6
G
Q
F