Publicité
Les langues disponibles
Les langues disponibles
should be replaced. To reinstall, push new brush back into brush box.
If replacing existing brush, maintain same orientation as when
removed. Replace the brush cap (do not overtighten). Replace end
cap and two screws. Tighten securely.
Cleaning
Blowing dust and grit out of the main housing by means of an air
hose is recommended and may be done as often as dirt is seen col-
lecting in and around the air vents. Always wear proper eye and
respiratory protection.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be performed by authorized service centers or
other qualified service organizations, always using identical replace-
ment parts.
NOTE: Unit may be converted to a 3-wire twist lock cord set at an
authorized service center.
Lubrication
Closed-type, grease-sealed ball bearings are used throughout. These
bearings have sufficient lubrication packed in them at the factory to
last the life of the chop saw.
Accessories
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous.
Use only high-strength Type 1 organic bonded wheels rated 4100 rpm
or higher.
Recommended accessories for use with your tool are available at
extra cost from your local service center. If you need any assistance
in locating any accessory, please contact GRABBER Construction
Products, 205 Mason Circle, Concord, CA 94520 or call 1-800-477-
TURN (1-800-477-8876).
Full Warranty
GRABBER heavy duty industrial tools are warranted for one year from
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information, call
1-800-477-TURN (1-800-477-8876). This warranty does not apply to
accessories or damage caused where repairs have been made or
attempted by others. This warranty gives you specific legal rights and
you may have other rights which vary in certain states or provinces.
9
Publicité
