Publicité
Curing Filter
The curing filter should be used when working with light-cured composites. When applying these materials,
unfiltered light from the headlight can cause premature curing of the composite. The curing filter is made up
of two components, the black bezel ring that is secured to the end of the headlight and the orange filter that
can be flipped up and down as needed during procedures.
• To remove the curing filter, grasp the headlight with one hand and the black bezel ring with another and
pull. It is held with a friction fit and will separate from the headlight with moderate force.
• To attach the curing filter, flip the orange filter to the UP-position and carefully press the black bezel
ring onto the headlight, making sure the hinge is at the top.
Do not directly pull or press on the orange filter.
Side Shields
The side shields offer additional protection. We recommend keeping the side shields installed to maintain
the device's ANSI Z87.1 certified protection, but can be removed if preferred.
• To remove the side shields, grasp the frame with one hand and the side shield with another and pull
straight down. They are held with a friction fit and will separate from the frame with moderate force.
• To attach the side shields, align the locking tab of the side shield with the slot on the bottom of the
frame and push straight up with moderate force, making sure the correct side shield is being installed
on the correct temple arm. When properly installed, the front of the side shields will curve around
the front of each lens.
INSTRUCTIONS FOR USE AND CARE
See back cover for Customer Care or Technical support contact information | Customers outside our direct sales regions, contact your local distributor
Orascoptic ™ Dragonfly ™ Powered Loupe
Head Strap
We recommend tightening the head strap during use to help distribute the weight around your head
instead of on your nose. The frame should fit comfortably with minimal pressure on your nose.
• While holding down the button on the slider bead, tighten or loosen the headstrap as needed. Release
the button to lock the slider bead at the desired position.
• The head strap is made of an elastic material that can stretch over the battery pods to remove or replace
if worn out.
Lens Cleaning Cloth
Orascoptic lens cleaning cloths are made of high quality microfiber material to absorb and remove dust,
smudges, fingerprints, or other liquid splatter. They are ideal for cleaning lenses, telescopes, and side shields
without leaving streaks or scuff marks. They can be used dry or with your chosen cleaning solution as
described in the Cleaning and Disinfecting section of these instructions.
One lens cleaning cloth has been provided with your Dragonfly
powered loupe. Please call our Customer Care Specialists or your
authorized Orascoptic distributor to purchase additional cloths.
13
Publicité
